| Job Title |
Transformer Assembler Ii |
| Job Description |
Assembles Transformers According To Specifications, Performing
Any Combination Of Following Tasks: Reads Work Order To
Determine Assembly Procedure Specified By Customer. Cleans Coils
To Remove Materials Accumulated During Production Processing.
Removes Accessories From Coils, Using Screwdriver, And Wraps
Coils With Paper And Tape, Leaving Ends Of Wire Leads Exposed.
Inserts Ends Of Wire Leads Of Cores And Coils Into Wire
Stripping Machine To Remove Coating From Wires. Inspects And
Twists Stripped Wires Together By Hand To Join Designated
Colored Wires. Disassembles Cores To Facilitate Attachment Of
Coils And Attaches Cores To Coils, Using Cloth Tape And Glue.
Secures Core/coils, Using Metal Strapping, Metal Cutters, And
Band Clippers. Positions Wooden Wedges That Facilitate Further
Processing Of Units In Designated Openings Of Core/coils, Using
Rubber Hammer. Turns Knobs To Set Controls Of Test Machine To
Verify That Core/coils Operate Within Specified Range, Attaches
Clips To Wire Leads Of Core/coils, And Observes Machine Dials To
Determine Test Results. Routes Defective Core/coils For Rework.
Places Component Parts Of Terminals In Press, Activates Press To
Join Parts; Or Positions Parts In Fixture And Joins Parts, Using
Solder And Soldering Iron, To Fabricate Terminals. Attaches
Terminals To Core/coils, According To Work Order, Using
Handtools, Spacers, And Soldering Iron. Applies Adhesive To
Inside Of Transformer Case Side Sections. Positions And Aligns
Wires And Terminals Of Core/coils With Openings In Sections.
Positions Core/coil And Side Sections In Welding Machine, Aligns
Seams Of Sections For Welding, And Presses Buttons To Activate
Welding Machine To Weld Seams. Attaches Clip Probes To
Transformer Terminals, And Activates Test Equipment To Determine
Whether Units Meet Specifications. Positions, Inserts, And
Attaches Transformer Parts, Such As Insulation Panels, Front And
Back Metal Covers, And Base Plates To Complete Assembly Of
Transformers, Using Handtools. Stamps Identification Numbers On
Base Of Transformer, Using Metal Dies And Hammer. Repairs
Transformers With Minor Defects.
|
|
